Rekey Locks after Buying a House in Devore, Before You Unpack

What to know first in Devore

A thorough rekey after a home purchase starts with a walk-through. We count every keyed cylinder: front deadbolt and knob or handleset, garage entry door, back and side doors, keyed patio handles, gates, sheds and the mailbox. Then we look at brands and keyways. Many resale homes in Devore have a mix, say Kwikset on the front and Schlage on the garage door, and those two use different keyways (KW1 and SC1), so they can't share one key as they stand. We can swap the odd cylinder or replace that lock so one key runs the whole house. Kwikset SmartKey locks are rekeyable too; we set them to your new key so the old one no longer turns them. High-security cylinders such as Medeco or Mul-T-Lock may need restricted blanks or authorized service, and we'll tell you if yours fall into that group. Last, we flag hardware that isn't worth rekeying: worn latches, wobbly deadbolts, a bargain lock on the door from the garage. You decide what gets rekeyed and what gets replaced.

What we can do on-site

• Keying the whole house alike. Kwikset's SmartKey cylinders and its older pinned cylinders both take the same KW1 key blank, so a house with a mix of the two can still share one key. Schlage's standard five-pin SC1 locks behave the same way among themselves. The real obstacle is a lone off-brand or import lock, which we usually replace rather than chase scarce parts for.
• Mailbox lock change. A mailbox lock is a small cam lock, and the right replacement comes down to measurements: cylinder length, cam length and offset, and which direction the cam turns. We match those so the door closes flush and the cam catches the frame. On HOA-owned cluster boxes, we work only on the compartment the association confirms belongs to you.
• Lock condition check and upgrades. If you want the rekey to do double duty, we can load security pins, such as spool or serrated top pins, into cylinders that accept them, which makes picking and bumping much harder. Swapping short strike screws for three-inch screws that bite into the stud is another quick improvement. Each upgrade is priced separately, so you can pick and choose.
• Security screen doors and iron gates. Wrought-iron courtyard and side gates take a beating from sun, sprinklers and slamming. Their locks are often rim or mortise gate locks, or keyed levers mounted in a weld-on box. We service, rekey or swap those cylinders to match the house, and replace gate hardware that has rusted past the point of latching reliably.
• When the seller's keys don't fit. It's surprisingly common to close escrow holding a ring that opens the front door and nothing else. After we confirm you own the home, we open the remaining locks without damage whenever the lock allows it, using picks or decoding tools, then rekey them to your new key so the missing originals no longer matter.

Local factors in Devore

Long commutes shape how you rekey. Many buyers in Devore leave before dawn and get home after dark, so the house sits empty most of the day. We start at 6:30 a.m. every day and work until 11:30 p.m. That makes a before-work or evening rekey realistic. Since the garage entry is often your everyday front door, that lock gets extra attention, and a keypad deadbolt can spare you a lockout at five in the morning.

Inland heat bakes exterior locks. Lubricant dries, pins gum up, and keypads on sun-facing doors wear out faster. When we rekey after a purchase in Devore, we clean and lubricate each cylinder with a dry graphite or PTFE product rather than oil that attracts dust, replace tired springs, and check keypad batteries, which hot weather drains faster than many owners expect.

Older homes in Devore often carry decades of key history: original knob locks, deadbolts added by a later owner, maybe a rim lock on a back door. Vintage cylinders can be stiff or corroded, and some original hardware isn't worth re-pinning. During a post-purchase rekey, we'll tell you which locks deserve new pins, which deserve retirement, and whether those older doors and frames will hold a modern deadbolt properly.

Example situations

• Consider a bank-owned home off Palm Avenue bought as a first house. The preservation company changed the locks at foreclosure, likely to a code shared across many properties, and the lockbox was opened by every agent who showed it. In a case like this, rekeying every exterior lock, plus checking for broken latches left over from the vacancy, would be the first job before anything else.
• For example, a couple closes on a 1960s single-story home in Cable Canyon, and the seller's agent hands over three different keys plus a garage remote. During the walk-through we'd find a Kwikset front deadbolt, a Schlage knob on the garage entry door and a padlock on the side gate. A typical plan: re-pin what matches, swap the odd cylinder, and leave them with one key for every door.
• Consider a buyer who purchases a duplex near Glen Helen Raceway, moves into one side and inherits a tenant in the other. Their own unit can be rekeyed the day they take possession. The tenant's unit is different: a typical plan is giving proper written notice, rekeying at the agreed time, handing the tenant new keys on the spot, and confirming the main door has a working deadbolt.
• Picture a buyer who agreed to a three-week rent-back so the sellers could finish packing. The temptation is to rekey at closing, but the sellers still live there. The better plan is booking the rekey for the morning they hand over the keys, then cutting new ones before the movers back into the driveway. Coordinating that around an escrow timeline is routine work for us.

How the visit works

1. Book around your possession date. Rekeying works best on a known date. Give us your expected close of escrow and possession date, plus any contractor work planned before move-in. We'll suggest the right timing: immediately if the home is empty, or right after the rent-back ends or the remodel wraps up.
2. Bring proof of ownership. We verify every buyer before rekeying. A driver's license with your name, matched to the final settlement statement or recorded deed, is ideal. Buying through a trust or LLC? Bring documents showing you're authorized for that entity. It takes a couple of minutes and keeps us from rekeying for the wrong person.
3. Walk the property and count cylinders. Before quoting, we inventory the house. Each keyed cylinder gets checked for brand, keyway, wear and whether it can join a keyed-alike set. We also note keypads, smart locks and any high-security cylinders. You see the full list and price, and you decide what's rekeyed, replaced or left for later.
4. Re-pin each cylinder. We remove each cylinder, push out the old pins, and load a new combination using our key gauge and pinning kit, matched to the fresh key we've cut. Master pins aren't needed in a single-family house, which keeps the locks simpler and harder to manipulate. Then each cylinder goes back exactly as it came out.
5. Reset codes and test every key. With the pins done, we clear keypad codes, factory-reset smart locks and pair them to your phone. Then we test every new key in every lock, from inside and outside, with the door open and closed. A key that turns stiffly gets corrected now, not discovered when you're standing on the porch with groceries.
6. Hand over the keys and the record. The visit ends with keys in your hand and a clear record of the work. Keep it with your closing papers. It lists the locks we handled and the keying, which makes later additions, like a new smart deadbolt, easy to match. Then reset the garage remotes and you're done.

What affects the cost

• Number of cylinders. The count drives most of the price. A starter condo might have two keyed locks; a larger home with a garage entry, side door, patio handle, gate and shed may have eight or more. A deadbolt and a knob on the same door are two cylinders. We count them with you before quoting.
• Mixed brands and keyways. Brand mixing is common in resale homes, since owners replace one lock at a time over the years. Locks that share a keyway are simply re-pinned; ones that don't need a cylinder swap or replacement to match. You choose whether one key for everything is worth the extra parts.
• Number and type of new keys. Cutting extra copies while we're already there is efficient, since our code machine is set to your combination. Standard keys can be duplicated later at many counters; restricted keys come back through us. Colored key caps or a tag for the workshop key cost little and make a shared ring easy to sort without labeling it with your address.

Every job gets a clear quote before any work starts. Call (951) 903-3193 with the details and we'll tell you what to expect for your situation in Devore.

Mistakes to avoid

• Hiding a spare outside the same week you rekey. A fake rock or a key on top of the door trim is the first place anyone looks, and it hands a stranger the very access you just paid to remove. Give a spare to someone you trust, or use a keypad code you can delete.
• Ignoring codes and electronic access. A rekeyed deadbolt with the seller's keypad code still active, or a smart lock still linked to their app, leaves the door open to them. The same goes for garage remotes and alarm codes. Reset everything programmable on the same day the keys change.
• Waiting until after moving in. Once your belongings are inside and life gets busy, rekeying slides down the list for weeks or months. Meanwhile, every old key still works. Book it for possession day; it's a short visit compared with everything else you're juggling that week.

What to do before we arrive

• Ask your agent to collect every key, remote and code from the sellers before closing, and to note how many there are. It won't make rekeying unnecessary, since nobody can account for copies made at a hardware store, but it tells you which locks exist and whether any are high-security.
• Schedule the rekey before movers arrive. Once boxes and furniture are inside, you're protecting more behind locks whose key history is unknown, and moving day itself brings helpers through every door. Even a morning appointment on possession day, before the truck shows up, closes that gap.
• Test each deadbolt with the door closed. If you have to push, pull or lift the door before the bolt will throw, the strike is out of line, and the bolt may not be fully extended even when it feels locked. A small strike adjustment fixes it, and a bolt that seats completely is far harder to force back.
• Factory-reset every smart lock instead of just deleting users in an app. A reset removes the previous owner's account access and any shared guest codes. Then set up your own account, create a strong master code and rekey the backup cylinder, since that key may still be sitting in someone's junk drawer.

Getting to Devore

Devore is about 8 miles from our San Bernardino base, roughly 14 minutes in light traffic via Kendall Drive or Palm Avenue to I-215 North, through the Devore junction onto I-15 North, exit Kenwood Avenue for Devore Heights. When you call, you get an arrival estimate based on where the technician is and the traffic at that moment.

Traffic matters more than mileage. We check conditions on I-215 and its connecting routes before quoting you a time, and we don't pretend a long drive through heavy congestion is a short one.

About Devore: A two-story Santa Fe depot served Devore as a railroad station from 1908 to 1930 and was demolished around 1958.

Planning a rekey in Devore?

Call (951) 903-3193 and tell us how many doors you want on the new key and the brand of the locks if you know it. We'll quote the rekey before any work starts.