Need a New Key but Not a New Lock in Devore?

What to expect in Devore

Open a typical Kwikset or Schlage deadbolt and the part that recognizes your key is a brass cylinder about the size of a thumb. Inside it, a plug holds five small chambers, and each chamber has a spring, a driver pin and a key pin. Your key lifts each key pin to a height that lines the pins up at the shear line, letting the plug rotate and retract the bolt. To change the key, we take the plug out, replace the key pins with different sizes that match a new key's cuts, and reassemble. The driver pins, springs, latch, bolt, trim and door are untouched. After that, the old key lifts the pins to the wrong heights and the plug stays locked, while the new key turns smoothly. It's a mechanical change with no wiring, no new door holes and nothing to program, and in Devore we usually do it right at your door.

What we can do on-site

• Deadbolts: new key, same bolt. A single-cylinder deadbolt is the easiest lock to rekey. We release the cylinder from the bolt body, re-pin it to a new key and refit it in a few minutes. The bolt, backplate and finish never leave the door. You get new keys, and every old copy stops working.
• Handlesets and decorative entry hardware. A heavy brass handleset from Baldwin or a similar maker is an investment, and re-pinning its cylinders is almost always the smarter move. We check that the lock body and trim are sound, and we take care with lacquered or living-finish brass, which marks easily when handled carelessly.
• Smart locks and keypads with a key override. Smart deadbolts usually keep a conventional key cylinder as a backup, and that cylinder can often be rekeyed independently of the electronics. We change the key and leave the keypad, app and wiring alone. Then we remind you that PIN codes are a separate matter.
• Patio doors, security gates and screen doors. Hookbolt and mortise-style locks on patio and security doors can often be rekeyed in place, though some are riveted into the frame and need replacing. We identify the model first and tell you what's feasible before we begin, so there are no surprises midway through the visit.
• An honest rekey-or-replace check. Our recommendation depends on the lock, not on what's easiest to sell. A sound deadbolt gets a rekey. A corroded one gets a cylinder swap. A cracked bolt body or a bent latch gets replaced. We show you the evidence and let you decide.

What's different about Devore

Properties with acreage have gates, barns, sheds and sometimes a guest house, each with a lock someone else once had a key to. Changing keys without replacing locks lets you reset all of them economically: padlocks re-pinned, gate cylinders swapped, house doors rekeyed. We bring a mobile kit so the whole property is handled in one visit. Tell us about the tool shed, the equipment barn and the guest cottage so nothing is skipped.

Inland heat bakes locks. Brass expands, lubricants dry out, and plastic parts in some budget locks warp. Rekeying a sound lock is fine, but a heat-damaged one may deserve a cylinder swap or replacement. We check the plug, test the latch and use dry lubricant, because oil collects dust and bakes into gum on hot afternoons in Devore. A short check each spring catches sticking before summer makes it worse.

Foothill and canyon homes in Devore tend to have outbuildings and long driveways with gates, and wildfire season keeps people thinking about who has access. Rekeying every door and gate in one visit gives you a clean slate. Dust and Santa Ana winds make dry lubrication, not oil, the right choice for locks exposed to the weather. We also check gate latches and padlocks that see the most wind-driven grit.

Example situations

• A renter who has just received a protective order asks her landlord for new locks. In certain protective order situations, California requires landlords to change them within 24 hours of a written request (Civil Code sections 1941.5 and 1941.6). The landlord books us, we confirm authority with the landlord, rekey the entry deadbolt, test the lock and hand the new keys to the landlord to give to her.
• A resident of Devore loses a key ring at the gym. There's no address on it, but the house key is on there, and she doesn't want to replace a handleset she loves. We rekey the deadbolt and latch to a new key, cut three copies, and the lost ring becomes a set of metal charms with no door to open.
• A property owner with a gated side yard discovers the padlock key was cut for a gardener who left long ago. The padlock itself is solid. We re-pin it, cut new keys and check the hasp, so the gate stays shut, the old gardener key is dead metal, and nothing has to be bought new.
• After a kitchen remodel, a family wants to be sure the contractor's crew can't come back in. The locks are a mix of sound deadbolts and a sticky back-door knob. We rekey the deadbolts, replace only the knob's cylinder, and leave the rest alone. They pay for what was actually needed, not for a full set of new locks.

How the visit works

1. Describe the lock and why the key needs to change. Count how many keyed locks you want changed and whether you still have a working key for each. A working key makes the job simpler, but it isn't required. Tell us about any smart locks, gates or padlocks so we plan time for them.
2. Show that you're allowed to change it. California's Locksmith Act, administered by the Bureau of Security and Investigative Services, is why licensed locksmiths ask these questions. Our license is LCO7891, and you can look it up at search.dca.ca.gov. The check takes a minute and protects you as much as us.
3. Inspect the lock and choose rekey, cylinder swap or replace. Alignment problems often disguise themselves as lock problems. If the bolt drags because the door has shifted, we adjust the strike or hinge screws first. Then we decide whether the cylinder needs any work at all.
4. Remove the cylinder and re-pin it. On a deadbolt, the cylinder comes out through the bolt body; on a knob, through the rose or a release tab. The method differs, the idea doesn't: expose the plug, swap pins, reassemble. We work over a tray so nothing rolls away into the planter bed.
5. Test the new key and the working door. A rekey is only done when the old key fails and the new key works every time. We check both, plus any spare keys. If the door still sticks, we adjust the strike or hinges while we're there rather than leave you with a new annoyance.
6. Hand over keys and check what's left. The last step is a question: who else needs a key? Family, a neighbor, a pet sitter? We cut them now so nobody has to be guessed at later. Then you approve the work, we settle up as quoted and leave the door as we found it, only with a new key.

How we quote the job

• How many keyed cylinders you're changing. The count of keyholes drives time on site more than anything. A single front-door deadbolt is a quick job. A house with a front door, back door, garage entry, side gate and shed is several jobs in one visit. Tell us the total when you call and we quote accordingly.
• Brand, keyway and security level. Pin counts matter too. Five-pin cylinders are the norm; six-pin cylinders and sidebar designs take more care and sometimes special blanks. We identify the cylinder type from a photo when we can, so the quote matches what we find at the door.
• Timing, travel and add-on work. Travel across Devore is part of the service call, and early-morning or evening visits fit within our Sunday-through-Thursday hours. Friday and Saturday have the same hours as every other day. Bundling every lock into one visit keeps the total down, and booking ahead lets us bring the right parts.

Every job gets a clear quote before any work starts. Call (951) 903-3193 with the details and we'll tell you what to expect for your situation in Devore.

Common errors that cost time and money

• Rekeying a rental without permission. A tenant who changes locks without the landlord's consent can break the lease and block emergency access. Ask in writing first. Landlords have their own obligations too, including working deadbolts on main entry doors under Civil Code section 1941.3.
• Assuming a new key cancels keypad codes, app guests or remotes. The key and the electronics are separate systems. Changing one leaves the other open. After a rekey, review every PIN, app invite and garage remote, and remove anyone who shouldn't have access.
• Buying a DIY rekey kit for the wrong brand. Kits are built for specific keyways, and a Kwikset kit won't help a Schlage lock. Pins that look similar can sit at the wrong depth. Check the brand and keyway before you order, or let a locksmith handle it.

What to do before we arrive

• Keep the brand and model if you have the box or receipt. A model number lets us check whether parts and cylinders are available, which matters for older or decorative locks. Take a photo of the paperwork and file it with your home records.
• Don't let copies pile up. A key you can copy at a kiosk for a few coins will be copied. If you want control, ask about restricted keys. Even if you don't, keep a count and ask anyone you hand a key to for it back later.
• Treat a rekey as a mini tune-up. While the lock is apart, tighten the mounting screws, check the strike plate, clean the latch and add a dry lubricant. A smooth lock is also less likely to jam when you're in a hurry with a handful of groceries.
• Look at the door as well as the lock. If the bolt drags or the latch misses the strike, the door may have moved. A quick adjustment of the strike or hinges can fix what looks like a lock problem. We check this at every visit before rekeying.

Service in Devore

Devore is about 8 miles from our San Bernardino base, roughly 14 minutes in light traffic via Kendall Drive or Palm Avenue to I-215 North, through the Devore junction onto I-15 North, exit Kenwood Avenue for Devore Heights. When you call, you get an arrival estimate based on where the technician is and the traffic at that moment.

Homes and businesses just off Kimbark Avenue are routine stops for us. Give the suite or unit number and any gate instructions, and say whether the van can park out front or should pull into a side lot.

About Devore: Before taking the Devore name, the land in the northern corner of Rancho Muscupiabe was called the Martin District, the Guernsey Tract and the Glen Helen Tract.

Planning a rekey in Devore?

Call (951) 903-3193 and tell us how many doors you want on the new key and the brand of the locks if you know it. We'll quote the rekey before any work starts.