Mentone Lock Changes for Homeowners, Renters and Landlords

What to know first in Mentone

There are three ways to change locks, and choosing among them depends mostly on the condition of what's already on your doors. Rekeying keeps the hardware and swaps the pin stack inside each cylinder, so the old key no longer reaches the shear line. It's the right call for sound locks you like. Replacing only the cylinder works on mortise locks, rim locks and Euro-profile multipoint doors, where the cylinder is a separate part. Replacing the whole lockset makes sense when the latch sticks, the knob wobbles, the finish has peeled in the sun, or the lock is an ungraded bargain model. In Mentone, many homes end up with a mix: re-pinned deadbolts on the front and garage entry, new levers on a back door that has worn out, and a matching cylinder added to the security screen door. We explain each recommendation door by door and price the options so you can choose. Nothing gets replaced just because we happen to have stock on the truck.

Work included on a typical visit

• Rekeying your existing locks. Rekeying is pure pin work. Inside a five-pin Schlage or Kwikset cylinder, the bottom pins are cut to lengths that match one key's cuts. We dump those pins, choose new lengths from a fresh bitting, and load them with tweezers and a plug follower so the springs and top pins never escape. Kwikset SmartKey cylinders reset with a tool instead.
• New lockset installation on existing door prep. Swapping hardware sounds simple until an old faceplate mortise is square-cornered and the new latch is round, or the door is 2 inches thick instead of 1-3/4. We carry adapters, thick-door kits and sharp chisels, so the new lock sits flush, the latch retracts freely and the deadbolt reaches full throw without dragging.
• Restricted keyways and high-security cylinders. If you change locks because keys keep getting copied, a restricted keyway addresses the cause. Patented systems from Medeco, Mul-T-Lock and ASSA Abloy use blanks that hardware stores can't cut, and duplicates require the owner's card or signature. We can fit these cylinders into many existing deadbolts and handlesets.
• Keying every door alike. Keying alike is convenient, but sometimes you want exceptions: a side gate key for the gardener that doesn't open the house, or a workshop key only you carry. We can set those up as separate keys or, on compatible hardware, build a simple master arrangement so your key opens everything while helpers' keys open only their areas.
• Urgent safety lock changes. California gives protected tenants specific lock rights. Under Civil Code 1941.5 and 1941.6, the landlord must change the locks within 24 hours of the tenant's written request in certain situations involving a protective order or similar documentation. If the landlord doesn't, the tenant may have the locks changed and must then give the landlord a key. We can work for either side.

How Mentone shapes the job

Older homes often hide more keyed locks than people expect: original mortise locks, service porch doors, and decades of add-on deadbolts. Before you change locks in an older Mentone house, we check whether original hardware can be rekeyed and serviced instead of replaced, which preserves period trim and avoids filling oversized door pockets. Where doors were bored at odd sizes or old jambs won't hold a modern strike, we explain the fix honestly, including when a carpenter should go first.

Foothill homes face wind-driven dust and, in fire season, the possibility of evacuation. If you change locks on a canyon or foothill property near Mentone, keep a spare key or code where a trusted neighbor can reach it, so someone can check the house or get pets out during an evacuation. Dry lubricant matters here too, because Santa Ana winds push grit into exterior cylinders.

Long commutes mean long empty hours at home, and a lock change for commuters should account for that. In Mentone, many households add a smart deadbolt that reports its status, so you can confirm the door is locked from the office. We can schedule a lock change early, starting at 6:30 a.m. every day of the week, so you don't lose a full day of work.

Common situations

A woman renting a duplex near Crafton Avenue has a police report involving a former partner who still has a key. She gives her landlord a copy and asks for a lock change. Aware of the 24-hour rule in the Civil Code, the landlord calls us. We'd confirm his authorization, remove the front and back door locks and install new sets with different keys. The tenant gets her keys, the landlord's spare is handled separately, and the old keys no longer work.

• A typical call: a roommate in a Mentone rental moves out after an argument and keeps a key. The remaining tenant contacts the property manager, who agrees to a rekey as long as the office receives a copy. We'd check the lease and ID, re-pin the entry deadbolt and handle, cut keys for each remaining tenant plus one for the manager, and note who received them.
• Picture a tenant who has just been granted a restraining order and gives a copy, with a written request, to the apartment manager near Crafton Park. The manager calls us that afternoon to meet the 24-hour deadline. We'd rekey the entry deadbolt and knob, check the sliding patio door latch, add a secondary bar, and hand the new keys only to the tenant and the manager's office.
• For example, a 1930s Spanish revival home near Redlands Municipal Airport still has its original mortise lock behind a handsome but worn brass escutcheon. The owner assumed that the only way to change locks was a new door. We'd remove the mortise cylinder, rekey or replace it, clean and service the lock body, and keep the original trim so the door keeps its character.

From your call to the finished job

1. Tell us the reason and count the doors. On the phone, we ask a few practical questions: how many doors, which brands, whether anything is damaged or sticking, and whether you rent or own. Photos of each lock help. The answers shape the quote and tell us whether to bring extra hardware or a high-security cylinder to your Mentone address.
2. Verify residence or ownership. Executors, trustees and property managers can authorize a lock change too, with the right paperwork: letters testamentary, a trust document, or a management agreement or work order. If the papers are somewhere you can't reach, we'll talk through what else might work before anyone touches a lock.
3. Inspect each lock and choose rekey or replace. We measure backset, bore and door thickness wherever new hardware is on the table, because a lock that doesn't fit the existing prep means drilling, filler plates or an extra trip. Measuring first means the new lock goes into holes it was designed for, and your door edge stays clean.
4. Re-pin or install the hardware. Most of the work happens at the door and in the van. New keys are cut to code on our machine, cylinders are pinned at a bench, and hardware comes from stock. If a special finish or high-security cylinder isn't on hand, we secure the door with a rekey and come back to finish.
5. Test every key on every door. Each new key gets tried in each lock it should open, with the door open and again with it closed, because a strike that binds only shows up when the door is shut. We check the inside thumbturn, the deadbolt's full throw, and that the latch catches on its own.
6. Hand over keys and records. We leave you with practical next steps: where to keep a spare, how to change keypad codes, when to lubricate, and what to watch for as doors shift with the seasons. If a lock feels different in the following days, call and describe it; small strike adjustments are common as new hardware settles.

How we quote the job

• Rekey versus new hardware. The single biggest factor is whether your locks can be rekeyed. A rekey uses pins and labor, while a replacement adds the price of each lockset. Many homes split the difference: rekey the good hardware, replace only what's worn. We quote both options per door so you can see where the money goes.
• Door condition and prep work. Doors in inland Southern California shift. Heat swells wood doors, stucco homes settle, and strikes drift out of line. If a new deadbolt can't throw fully until the strike is relocated, that adjustment becomes part of the job. It's modest work, but it shows up on the quote.
• Timing, travel and urgency. Our hours are 6:30 a.m. to 11:30 p.m., seven days a week. A late-evening lock change within those hours is possible, and we'll tell you on the phone whether timing affects the quote. Planned move-in rekeys are the easiest to schedule.

Every job gets a clear quote before any work starts. Call (951) 903-3193 with the details and we'll tell you what to expect for your situation in Mentone.

Advice before you book

• Ask for keys cut from code rather than copied from another copy. A key duplicated from a worn duplicate inherits its wear and gets sloppier with every generation. When we change locks, we cut original keys from the bitting on our machine, so every key you receive is as crisp as the first one.
• When you get new keys, decide right away who receives them and write it down: names, how many, and the date. It sounds fussy, but that record tells you when it's time to change locks again. If a key holder leaves your life later, you'll know whether their key came back or not.
• If you rent in Mentone, ask your landlord in writing before changing anything, and offer a copy of the new key. A short email creates a record. Most leases require consent, and California gives landlords a right to enter with notice, so a lock they can't open causes friction. Safety situations covered by Civil Code 1941.5 follow their own rules.
• Include the security screen door when you change locks. These doors usually have their own deadbolt or deadlatch, and many accept a cylinder that can be rekeyed to your new house key. On hot afternoons plenty of families leave the wood door open for airflow and lock only the screen door, so that cylinder matters as much as the deadbolt.

Mistakes to avoid

• Spraying oily lubricant into the keyway. It frees a sticky lock briefly, then attracts dust and turns into paste around the pins, especially in windy inland neighborhoods. If you've already done it, a solvent flush and dry lubricant may save the cylinder; otherwise a rekey with clean pins solves the problem.
• Over-tightening the through-bolts. Cranking the screws that hold a knob, lever or deadbolt together squeezes the mechanism and makes the latch or bolt drag. The lock feels solid at first and then starts sticking, especially when heat swells the door. Snug and even is correct; the door should close with one easy push.
• Changing only the front door lock. Burglars and former key holders don't care which door they use, and the garage entry door is often the weakest one in the house. If you change locks, change all of them, or rekey the rest to match, so no old key still works anywhere on the property.

Getting to Mentone

Mentone is about 20 miles from our San Bernardino base, roughly 27 minutes in light traffic via I-215 South to SR-210 East through Highland, exit San Bernardino Avenue in Redlands. When you call, you get an arrival estimate based on where the technician is and the traffic at that moment.

If you're close to Citrus Avenue, tell us which exit or cross street you're nearest. It trims the last mile and keeps the van from circling a block that looks right on the map but isn't.

About Mentone: Mentone takes its name from Menton on the French Riviera, and the Mentone Corporation, formed in 1886, bought about 3,000 acres on the south bank of the Santa Ana River.

New or replacement locks in Mentone?

Call (951) 903-3193 and tell us which doors and what kind of hardware you have in mind. If you already bought the lock, keep the box handy so we can check it fits the door, and we'll quote the install before any work starts.