Rekeying Your House in Colton: What a Full Rekey Covers

How this works in Colton

The age of a house shapes its rekey. Homes from the 1920s through the 1940s may still have mortise locks, some of them warded skeleton-key locks that can't be rekeyed in any meaningful way and are better retired in favor of a proper deadbolt. Mid-century ranch houses often have early Schlage knobs that still rekey well, if paint and grime haven't sealed the trim. Tract homes from the 1970s through the 1990s tend to mix brands, Kwikset, Schlage, Weiser and Weslock, so keying the house alike may mean swapping a cylinder or two to a common keyway. Houses built since 2000 usually arrive with builder-grade Kwikset SmartKey or Schlage locks on matching keys, which makes a house rekey quick. Custom homes may have Baldwin or Emtek handlesets whose decorative trim needs careful removal. Telling us when your house was built, and roughly what's on the doors, helps us bring the right pins and the right replacement cylinders to Colton.

How we can help in Colton

• Front entry deadbolt and handleset. The front door usually carries two cylinders: a deadbolt, plus a keyed knob, lever or handleset. On many handlesets the deadbolt is the only keyed part and the grip below is a thumb latch. We rekey whatever is keyed, check the bolt throws its full inch into the strike, and test with the door closed.
• Back, patio and French doors. Back doors usually have a knob and deadbolt like the front, and both get rekeyed. Sliding patio doors typically have a latch with no outside key; if yours has a keyed exterior cylinder, we'll check whether it can be re-pinned. French doors carry a handleset or deadbolt on the active door and flush bolts on the other.
• Side gates and yard padlocks. Side gates hold back pets and guard the route to your back door. Padlocks can sometimes join the house key if they have rekeyable cylinders; laminated hardware-store padlocks usually get replaced. Keyed gate latches can often be re-pinned. We'll sort through them as part of the house rekey.
• Older-house and mortise locks. Original hardware on a vintage house is worth keeping when it works. We take extra care with painted-over trim, aged set screws and brittle parts, rekey the cylinders that can be rekeyed, and tell you honestly which locks offer little real security, so you can decide whether to upgrade them or simply add a deadbolt.
• Household key plan and spares. Rather than handing a key to every helper, consider a keypad or a lockbox for people who come occasionally, such as a dog walker or house cleaner. Codes can be changed in seconds; keys have to be collected or the house rekeyed. We'll help you decide what belongs on a key and what belongs on a code.

Local factors in Colton

Inland sun is hard on exterior hardware, and a house rekey in Colton is a good chance to see how yours has aged. West-facing doors and side-gate padlocks bake, finishes crack, lubricant dries and cylinders stiffen. We clean and relubricate with a dry graphite or PTFE product instead of oil, which collects dust. Electronic locks have their own heat problem: batteries wear out sooner, so we check them and suggest replacing them before they fail.

In a family neighborhood the problem is volume. Teenagers, grandparents, babysitters, carpool parents and dog walkers all pick up a key over the years, and kids lose them. A house rekey in Colton is the natural time to cut a short list: one key per adult and driver, a labeled spare, and codes for everyone else. Kids' keys go on distinctive rings with no address tag. Evening appointments run until 11:30 p.m. every day.

A house from before 1980 has usually had its locks replaced one door at a time, so a house rekey in Colton starts by sorting original hardware from later additions. Early Schlage knobs and mortise cylinders often re-pin well once old paint is cleaned off the trim. Warded skeleton-key locks have nothing to rekey and are better backed by a modern deadbolt. Expect at least one door with only a knob, and a screen door or side gate that still opens for a previous owner's key.

Common situations

• Picture a house on a big lot with a detached garage, a workshop and a pump house, plus three padlocks on fence gates. The owner wants the house on one key and the outbuildings on another, so helpers can reach the tools without entering the home. We rekey the doors into two zones, replace two cheap padlocks with rekeyable ones, and key them to the outbuilding key.
• Imagine a house near Fleming Park with wrought-iron security screen doors at the front and back, each on its own key, plus two keys for the doors behind them. Four keys for two entrances is a lot to juggle. During the house rekey we re-pin the screen door cylinders to the Kwikset keyway the house already uses, and everything runs on one key.
• A typical find: during a house rekey, the back door turns out to have only a keyed knob, no deadbolt at all. The owner assumed it had both. We rekey the knob with the rest of the house and, with the owner's go-ahead, install a deadbolt keyed to match, set its strike into the framing with long screws, and test it with the door closed.
• Picture a 1930s Spanish-style house in Terrace Historic District with its original mortise lock on the arched front door. The cylinder on the outside is threaded into the lock body and can be re-pinned, so the door keeps its character. The interior skeleton-key locks don't matter for security, and the back door gets a modern deadbolt keyed to the front cylinder.

Step by step with Julian's Locksmith

1. Walk your house before you call. Start at the front door and walk the outside of your house, including the garage. Count every keyhole: deadbolts, knobs, handlesets, screen doors, gate padlocks, a shed or casita. Note the brand stamped on each lock face. That count is the heart of an accurate house rekey quote.
2. Gather proof the house is yours. Verification is quick when the papers are ready. Keep your ID and one document tying you to the address near the front door. If the house is newly purchased and your license still shows an old address, escrow or closing documents with your name on them do the job.
3. Walk-through and label every door. The walk-through doubles as a quick security check. We note doors without deadbolts, strikes held by short screws, sliders without a secondary lock and gates that don't latch. None of it is required for the house rekey, but it's good to know while someone experienced is standing at your doors.
4. Settle the key plan. Decide which doors share a key. Most houses go on one key; some keep a casita, workshop or rented room on its own. If brands don't share a keyway, we'll suggest which cylinders to swap so the plan works. Then we agree on how many keys to cut for each zone.
5. Rekey door by door and test. We pull one cylinder at a time, re-pin it to the new combination and put it straight back, so the house is never left with an open door. Each lock is tested with the new key from inside and outside, with the door shut, and the old key is tried so you can watch it fail.
6. Close the routes keys don't cover. A house rekey changes cylinders, not codes. Before we leave, we help you clear the garage opener's memory and re-pair the remotes you're keeping, change the garage keypad code, remove old smart lock users, and retire any hidden spare. Then the new keys and a short key list are yours.

Pricing factors

• Age and condition of the locks. Sun and dust are hard on exterior locks. A cylinder that's been baking on a west-facing side door for twenty years may need cleaning, new springs or replacement. Locks on newer houses usually re-pin quickly, while vintage hardware deserves more care and sometimes more time.
• Extras around the property. Security screen doors, side-gate padlocks, keyed gate latches, shed doors and privately owned mailboxes all add to a house rekey. Rekeyable padlocks can join your key; cheap ones are usually replaced. A mailbox on a Postal Service cluster box goes through the post office instead.
• Missing keys and stuck cylinders. A lock without a working key can still be rekeyed, but it may need to be picked or decoded first. SmartKey locks without a key lose their quick reset. Seized cylinders, broken key pieces in the keyway and stripped screws add labor. We price those individually when we find them.

Every job gets a clear quote before any work starts. Call (951) 903-3193 with the details and we'll tell you what to expect for your situation in Colton.

Practical tips before you call

• Look at security screen doors as their own locks. They often run on a separate key and get skipped. Many accept Kwikset or Schlage keyway cylinders and can join the house key; others need a manufacturer cylinder. Note the brand on the screen door lock when you count.
• Book the house rekey for an evening or early morning when you'll be home. We schedule Colton homes from 6:30 a.m. to 11:30 p.m. every day of the week, Fridays and Saturdays included. A weekday evening visit means you don't have to take time off work.
• Check that each deadbolt actually throws its full bolt. Lock it with the door open and look: a residential deadbolt should extend about an inch. Then close the door and lock it again. If it stops short or needs a shove, mention it so the strike can be adjusted during the rekey.
• Treat the garage-to-house door as an exterior door. Anyone with an old remote or a known keypad code can reach it, so lock it at night and when you're away, and include it in the house rekey. If it has only a knob, ask about adding a deadbolt keyed to match.

Mistakes to avoid

• Buying matching locks for one door and expecting the house key to fit. Different brands use different keyways, so a new Schlage lever won't take your Kwikset key. Tell your locksmith before buying, or let us supply hardware keyed to the rest of the house.
• Forgetting codes and remotes. A rekey doesn't touch the garage opener, the garage keypad, smart lock codes or the alarm. Former residents and helpers who knew those codes can still get in until you clear the opener's memory and change every code.
• Skipping the garage-to-house door because the big garage door is "always closed." Old remotes, a known keypad code or an open side door put someone in the garage, and from there the house door is the only barrier left. It belongs in the rekey.

Getting to Colton

Colton is about 11 miles from our San Bernardino base, roughly 17 minutes in light traffic via University Parkway to I-215 South through San Bernardino. When you call, you get an arrival estimate based on where the technician is and the traffic at that moment.

Once the evening commute thins out on Cooley Drive, drive times usually shrink. That makes an evening call before closing a practical option for non-urgent jobs that you couldn't fit into the workday.

About Colton: Colton Crossing, where the California Southern Railroad crossed the Southern Pacific at grade in 1882, later carried BNSF and Union Pacific traffic until a flyover replaced it in August 2013.

Planning a rekey in Colton?

Call (951) 903-3193 and tell us how many doors you want on the new key and the brand of the locks if you know it. We'll quote the rekey before any work starts.