Change Key Without Replacing Lock: Rekey Options in Rubidoux

What to expect in Rubidoux

Open a typical Kwikset or Schlage deadbolt and the part that recognizes your key is a brass cylinder about the size of a thumb. Inside it, a plug holds five small chambers, and each chamber has a spring, a driver pin and a key pin. Your key lifts each key pin to a height that lines the pins up at the shear line, letting the plug rotate and retract the bolt. To change the key, we take the plug out, replace the key pins with different sizes that match a new key's cuts, and reassemble. The driver pins, springs, latch, bolt, trim and door are untouched. After that, the old key lifts the pins to the wrong heights and the plug stays locked, while the new key turns smoothly. It's a mechanical change with no wiring, no new door holes and nothing to program, and in Rubidoux we usually do it right at your door.

Work included on a typical visit

• Handlesets and decorative entry hardware. If your handleset's deadbolt and latch use different keys, we can bring them onto one so the front door needs a single key. That is a bonus of changing the key without replacing the lock: you can fix a daily nuisance at the same time as the security problem.
• Mortise locks in older homes and storefronts. Mortise locks sit in a pocket cut into the edge of the door, with a cylinder threaded into the face. We unscrew the cylinder, re-pin it or swap it, and thread it back without touching the lock body. For older homes and original storefront doors, that saves hardware that can't easily be replaced.
• Cylinder swaps when a rekey won't hold. Some cylinders are too worn, corroded or damaged to re-pin reliably. Rather than push a bad plug through another rekey, we fit a new cylinder of the same brand and keyway into your existing lock. You get a fresh mechanism and a new key, and the lock body, trim and finish stay on the door.
• Interchangeable cores: a swap in seconds. If your doors don't have interchangeable cores, we can sometimes convert them, but that is a hardware change rather than a plain rekey. We'll explain whether it's worth it. For a single home, a rekey is usually better. For a multi-door business, cores are worth considering.
• Smart locks and keypads with a key override. Smart deadbolts usually keep a conventional key cylinder as a backup, and that cylinder can often be rekeyed independently of the electronics. We change the key and leave the keypad, app and wiring alone. Then we remind you that PIN codes are a separate matter.

What's different about Rubidoux

Older Rubidoux homes often have hardware worth keeping: a heavy brass entry set, a mortise lock original to the door, glass knobs with a deadbolt added later. Replacing those means new bores, filled holes and a different look. Changing the key keeps the character. We rekey or swap the cylinder, keep the trim, and tell you plainly if the lock body is tired enough to retire.

Storefront doors in Rubidoux shopping centers often use mortise cylinders and Adams Rite deadlatches that can be rekeyed without touching the door. After an employee leaves or a lease changes, a rekey is faster than replacing hardware, and any landlord-required hardware stays in place. We cut keys for current staff and record the keying for your files. Most storefront rekeys finish before opening hours, with no disruption to customers.

Properties with acreage have gates, barns, sheds and sometimes a guest house, each with a lock someone else once had a key to. Changing keys without replacing locks lets you reset all of them economically: padlocks re-pinned, gate cylinders swapped, house doors rekeyed. We bring a mobile kit so the whole property is handled in one visit. Tell us about the tool shed, the equipment barn and the guest cottage so nothing is skipped.

Situations this covers

• A family has handed out the keypad code and the backup key for their smart deadbolt to a dozen people over the years. We rekey the backup cylinder, walk them through clearing old codes in the app and set two fresh ones. The hardware stays, the access list starts over, and the family finally knows exactly who can get in.
• A buyer closes on a house near Santa Ana River Wildlife Area and Louis Robidoux Parkland and knows the previous owner's family, agents and a lockbox company all handled keys. We rekey four cylinders so the only keys left are the ones she holds. The locks, finishes and strike plates stay where the sellers left them, and nothing new is drilled into the door or frame.
• A property owner with a gated side yard discovers the padlock key was cut for a gardener who left long ago. The padlock itself is solid. We re-pin it, cut new keys and check the hasp, so the gate stays shut, the old gardener key is dead metal, and nothing has to be bought new.
• After a kitchen remodel, a family wants to be sure the contractor's crew can't come back in. The locks are a mix of sound deadbolts and a sticky back-door knob. We rekey the deadbolts, replace only the knob's cylinder, and leave the rest alone. They pay for what was actually needed, not for a full set of new locks.

How the visit works

1. Describe the lock and why the key needs to change. Photos help more than descriptions. Snap the front of each lock, the edge of the door where the latch sits, and any stamp on the cylinder. We can often recognize the lock, say whether it's re-pinnable and quote the visit before we arrive.
2. Show that you're allowed to change it. We check photo ID and something linking you to the property, such as a utility bill, deed, lease or business license. Tenants should have the landlord's written okay. We do this on every job, because changing a key is the same as deciding who gets in.
3. Inspect the lock and choose rekey, cylinder swap or replace. This is the moment of honesty. We show you what we see: a smooth plug and clean bolt, or corrosion, wear or a loose body. Rekeying a failing lock wastes money, so we say so, and equally we won't recommend replacing a lock that's fine.
4. Remove the cylinder and re-pin it. We unscrew or release the cylinder, use a plug follower to push the plug out without losing the springs, and swap the key pins for ones that fit the new key. Each cylinder is measured twice. Then it goes back into the lock and the hardware is refitted.
5. Test the new key and the working door. Testing includes the lock's feel. A stiff turn, a gritty plug or a bolt that stops short means something else is wrong, and we fix it or tell you. Smart locks get their backup key tested as well as their keypad.
6. Hand over keys and check what's left. You receive the new keys, usually several, cut on site. We then walk through what a key change doesn't touch: keypad codes, app guests, garage remotes and spare keys held by relatives. Taking a few minutes for that review closes the gaps a new key can't.

What affects the cost

• How many keyed cylinders you're changing. Count carefully before you call: storm doors, patio doors, gate locks, the shed padlock. The cylinder you forget to mention is the one that keeps an old key alive. We'd rather quote a complete job than leave a gap in your security.
• Rekey, cylinder swap or full replacement. Rekeying usually costs less than replacing, but not always. A cheap, worn lock can cost almost as much to rekey as to swap for a new one, and the new one lasts longer. We'll tell you where the break-even sits for your particular hardware.
• Whether you have a working key. No key doesn't mean no rekey. We can usually get a lock open without damage and re-pin it. A lock that has to be drilled needs a replacement cylinder, and that changes the quote. We prefer non-destructive entry wherever the lock allows it.

Every job gets a clear quote before any work starts. Call (951) 903-3193 with the details and we'll tell you what to expect for your situation in Rubidoux.

What not to do

• Leaving old keys mixed in with new ones. After a rekey the old keys no longer work, but they look identical. A family member who grabs the wrong one gets locked out. Remove the dead keys from every ring and mark the new ones with a colored cap.
• Rekeying a rental without permission. A tenant who changes locks without the landlord's consent can break the lease and block emergency access. Ask in writing first. Landlords have their own obligations too, including working deadbolts on main entry doors under Civil Code section 1941.3.
• Expecting a rekey to make a weak lock strong. Re-pinning changes who can use the lock, not how well it resists force. A flimsy deadbolt or a short strike screw is still flimsy afterward. For better protection, add a quality deadbolt, a longer strike screw and a reinforced frame.

What to do before we arrive

• Photograph the lock before you call. Get the keyhole side, the edge of the door where the latch sits and any name stamped on the cylinder face. Those three photos let us recognize the lock, tell you whether it can be rekeyed and quote the visit before we arrive.
• Time the change with a trigger. After a move, a breakup, a lost ring, a contractor's last day or a tenant's departure, rekey within days, not months. The risk is greatest while old keys are fresh and the people holding them still remember which door they fit.
• Don't let copies pile up. A key you can copy at a kiosk for a few coins will be copied. If you want control, ask about restricted keys. Even if you don't, keep a count and ask anyone you hand a key to for it back later.
• Use a puff of graphite or PTFE spray in the keyway once a year, never household oil. Oil traps dust and bakes into gum in a hot, dry climate, while a dry lubricant keeps the new pins moving and the key turning without effort.

Getting to Rubidoux

Rubidoux is about 22 miles from our San Bernardino base, roughly 28 minutes in light traffic via Palm Avenue or University Parkway to I-215 South through San Bernardino, Colton and Grand Terrace. When you call, you get an arrival estimate based on where the technician is and the traffic at that moment.

If you're close to Valley Way, tell us which exit or cross street you're nearest. It trims the last mile and keeps the van from circling a block that looks right on the map but isn't.

About Rubidoux: Rubidoux High School on Opal Street opened in 1959 as the first high school in what was then called the West Riverside area.

Planning a rekey in Rubidoux?

Call (951) 903-3193 and tell us how many doors you want on the new key and the brand of the locks if you know it. We'll quote the rekey before any work starts.