Installing a Double Cylinder Deadbolt in Orange

How this works in Orange

A standard single-cylinder deadbolt has a key cylinder outside and a thumbturn inside. A double cylinder replaces the thumbturn with a second key cylinder, keyed alike so one key works both faces. The bolt, housing and strike are the same; the difference is that nobody can open the door from inside without a key. That is the whole point, and also the whole risk. The attack it defends against is specific: a burglar breaks glass in the door, a sidelight or a nearby window, reaches in and turns the thumbturn. If no glass sits within arm's reach of the thumbturn, a double cylinder adds nothing against kicking, prying or drilling, and it adds a lock-in hazard. In Orange, we start every double cylinder deadbolt installation by measuring where the glass is, what the door is used for, and whether the bolt and strike behind it are strong enough to deserve the upgrade.

Work included on a typical visit

• Exit and code check before we drill. Before drilling, we look at where occupants would leave in a fire, whether this door is the main route, and who lives or works inside. Building and fire codes drive the answer, and local departments enforce them differently. We won't fit a lock that traps people, and we say so before quoting.
• Swapping a double cylinder for a single cylinder. Double cylinder on a front door and nobody is sure where the key is? We can rekey it, swap it for a thumbturn model or, where it truly belongs, keep it and set up a better key plan. We explain which option fits your door and quote it before we begin.
• Keying, spare keys and the key plan. Because one key does everything, how you store it matters as much as the lock. We suggest a spot near the door but away from the glass, and a spare in a separate place. For households with kids or older relatives, we plan more carefully so nobody has to hunt in an emergency.
• Strike, jamb and frame reinforcement. A glass door is often weaker at the frame than at the lock. After installing the double cylinder, we fit a box strike with 3-inch screws into the framing, check the hinges and look for split wood at the strike. The deadbolt is only as strong as what it lands in.
• High-security and restricted-key double cylinders. A double cylinder concentrates risk in one key, so key control matters more. High-security cylinders resist picking and bumping and limit duplication to authorized holders. They cost more than standard locks, and we help you judge whether the door warrants it.

What's different about Orange

Downtown storefronts in Orange often have older glass doors, narrow stiles and transoms. The main entrance has occupancy rules, and exit hardware may be required, so a double cylinder rarely fits there. Back-of-house doors may be different, depending on occupancy and exit counts. We assess the building, explain which hardware suits each door and tell you when to check with the fire marshal or building department.

Older homes in Orange frequently have wood doors with divided glass panes close to the lock, and some already carry a double cylinder from a previous owner. These doors are often the main exit, so we usually recommend a strong single-cylinder deadbolt and laminated glass in the pane nearest the lock. For a rear door that isn't the main route, a double cylinder can make sense. We check stile width before drilling, since old wood can split.

Barns and tack rooms in horse country near Orange often have windowed doors, and tack is valuable. A double cylinder can protect a glass-panel tack room door, provided the barn's emergency exits stay free. In a barn fire, people and animals must move quickly, so we recommend keeping main barn doors operable from inside and using a keyed-both-sides lock only on a closet-style tack room.

Example situations

• A landlord in Orange owns a duplex. After a break-in through a rear door's glass, he asks for double cylinder deadbolts on both back doors. We explain that tenants must be able to leave quickly without a key, and that heavier single-cylinder deadbolts with long-screw strikes address the break-in better. We install those, and he arranges laminated glass for the panes.
• A host with a guest house near Orange Transportation Center and the historic Santa Fe depot wants a double cylinder so visitors can't leave doors unlocked from inside. We explain why guests, who don't know the key plan, are the people most at risk in a fire. We install a keypad deadbolt with a keyed override and an inside thumbturn instead, so codes change between stays and nobody searches for a key in the dark.
• A bungalow has a brass mail slot cut into the front door about eight inches from the deadbolt's thumbturn. The owner has read that a hooked wire fished through a slot can turn some thumbturns. A double cylinder would solve it but trap the household. We suggest sealing or relocating the slot, using a catch box, or mounting the deadbolt higher, and keep a normal thumbturn on the door.
• A man in Fairmeadow Eichler keeps a table saw and a bench full of tools in a detached garage with a glass-panel side door. Nobody sleeps there, and a roll-up door offers a second way out. A double cylinder deadbolt fits well. We install it on a box strike, key it to match his house key, and he carries the key on his ring with a spare kept in the kitchen.

From your call to the finished job

1. Talk through the door and the reason. Call (951) 903-3193 and tell us which door it is, what it's made of, where the glass sits and why you want a keyed-both-sides lock. A couple of photos help. We ask whether another exit exists, because that answer shapes everything that follows.
2. Check exits, glass and the people involved. We measure how far the glass is from the lock, test whether a hand could reach it, and note who uses the door. That tells us whether the double cylinder really adds security or only adds risk. You get a plain recommendation and the reasoning behind it.
3. Measure, quote and choose the hardware. With measurements in hand, we confirm the stile can hold a 2-1/8-inch bore, the thickness suits the lock and the finish matches your hardware. We quote the lock, the strike reinforcement and any keying before we start, and you can decline.
4. Prepare the door. We use a drill jig to cut the face and edge bores square, protecting the glass and finish with tape and padding. If the door is already bored, we clean and check the holes. A crooked bore makes the key bind, so we take care here.
5. Fit both cylinders, key them and set the strike. The two cylinders are tightened evenly, the bolt is adjusted for the backset and the keying is matched to your existing key or a new one. A heavy strike goes into the jamb, and we check the hinge side, because glass doors often give way at the hinges.
6. Test the lock and plan the key. Before we leave, you operate the lock yourself, including in a dim room, to see what an emergency exit would feel like. We help choose a spot for the key, check that a guest could find it and confirm every key works.

What affects the cost

• Door prep and thickness. A door already bored for a 2-1/8-inch deadbolt costs less to prepare than one that needs both bores cut. Thick doors need extension kits. Glass doors take extra care with masking and jig work. We measure before quoting so the prep is included.
• Glass protection you add separately. Protecting the glass is often the better fix, and it is priced apart from our visit. We don't install glass or film, so we explain what to request from a glazier and quote our own part clearly. That keeps the two jobs, and the two costs, from getting mixed together.
• Number of doors and scheduling. Visits inside our hours, 6:30 a.m. to 11:30 p.m. every day, can be scheduled around your day. Combining doors helps. Tell us how many doors, what each is made of and which need keying alike when you call.

Every job gets a clear quote before any work starts. Call (951) 903-3193 with the details and we'll tell you what to expect for your situation in Orange.

Common errors that cost time and money

• Giving out one key and no plan. A single key hung on a nail that only one family member knows about leaves everyone else dependent on that person. Spread the knowledge: everyone who lives there needs to know where the key is and how to use it.
• Leaving the key in the lock all day. It feels safe because you can always get out, but a key in the interior cylinder can be turned by anyone who breaks the glass and reaches in. If the key lives in the lock, you've paid for a double cylinder and kept the weakness.
• Using a double cylinder on a bedroom or an only-exit door. Bedrooms and the only route to an exit need to open without a key. A keyed-both-sides lock there can trap people, especially kids, during a fire, a medical emergency or an ordinary lockout from the wrong side.

Advice before you book

• Tell every adult in the household, and any regular visitors, where the key lives. A babysitter, a house guest or an older relative who has never seen the lock should be shown on arrival. A note taped inside a cabinet door can help, as long as it isn't visible from outside.
• Hang the key where a person leaving can reach it in the dark but a person outside cannot. A hook beside the door, high enough that small children won't play with it, is common. Keep it in the same spot every day. A key tucked in a drawer across the room defeats the safety point.
• Review the setup every year. Kids grow, guests come and go, and keys get moved. Walk through the exit drill again, check that the spare still works and make sure the key hook is where you left it. A small annual check keeps the lock from turning into a hazard.
• Measure the real distance. Picture an arm reaching through a broken pane and see whether it can touch the thumbturn; if it can't, a double cylinder adds nothing. Measure from the nearest glass edge to the thumbturn, and from the glass to the door's far side. Tell us both numbers when you call.

Reaching Orange

Orange is about 52 miles from our San Bernardino base, roughly 60 minutes in light traffic via I-215 South through Colton and Grand Terrace to SR-91 West. When you call, you get an arrival estimate based on where the technician is and the traffic at that moment.

Homes and businesses just off Katella Avenue are routine stops for us. Give the suite or unit number and any gate instructions, and say whether the van can park out front or should pull into a side lot.

About Orange: Orange was incorporated on April 6, 1888, and is the only city in Orange County planned around a central plaza, which earned it the nickname Plaza City.

New or replacement locks in Orange?

Call (951) 903-3193 and tell us which doors and what kind of hardware you have in mind. If you already bought the lock, keep the box handy so we can check it fits the door, and we'll quote the install before any work starts.