Skip to content
Julian's Locksmith

Los Alamitos, Orange County

Need a New Key but Not a New Lock in Los Alamitos?

Short answer: Usually yes. A locksmith removes the cylinder, swaps the small pins inside to fit a different key, and puts it back. The deadbolt, handle, finish and latch stay on your door, and the old keys stop working. Julian's Locksmith does this on site in Los Alamitos for most Kwikset, Schlage, Baldwin and similar locks. Call (951) 903-3193 and we'll quote it before starting.

Change Key without Replacing Lock in Los Alamitos, CA — Rekeying pins and a lock cylinder

Think of your options as a ladder. The lightest touch is rekeying: the cylinder stays, its pins change, and the old key stops working. One rung up is a cylinder swap, where we install a new cylinder, perhaps in a different keyway, inside your existing lock body. The heaviest is replacing the whole lock. Most people who search for ways to change a key without replacing the lock are asking for the first rung, and in Los Alamitos most locks qualify. We start there, move up only when the lock demands it, and explain each choice in plain terms. The decision is yours, and we won't push you up the ladder.

How this works in Los Alamitos

Most keyed entry hardware can have its key changed. Kwikset and Schlage deadbolts, knobs and levers, Baldwin handlesets, Weiser and many Yale locks all use cylinders built to be re-pinned. Older homes may have mortise locks, where the cylinder threads in from the face and can be re-pinned or swapped without removing the lock body. Interchangeable core locks accept a new core in seconds with a control key. Padlocks, cabinet locks and many mailbox locks can be rekeyed if they have a pin tumbler cylinder. Where the key can't be changed: keypad-only locks with no key cylinder, combination padlocks, cheap interior privacy sets, and cylinders so corroded the plug won't come out. In those cases the answer is a swap or a replacement, not a rekey. We check the hardware in Los Alamitos before promising anything, so you never pay for a change that can't work. We judge each lock by its cylinder and body, not by the logo on the faceplate.

How we can help in Los Alamitos

  • Door knobs and levers with keyed entry. Keyed entry knobs and levers hide the cylinder inside the outside knob or lever. We release the retaining clip or tab, slide out the cylinder, re-pin it and snap it back in. The knob, rose and latch stay exactly as installed, and the finish is never scratched or replaced.
  • Handlesets and decorative entry hardware. Handlesets combine a grip, thumb latch and deadbolt, and they're the pieces owners most want to keep. We rekey the deadbolt and the latch cylinder and can match both to a single key. Your handleset, with its finish and design, stays on the door exactly as you chose it.
  • Cylinder swaps when a rekey won't hold. Some cylinders are too worn, corroded or damaged to re-pin reliably. Rather than push a bad plug through another rekey, we fit a new cylinder of the same brand and keyway into your existing lock. You get a fresh mechanism and a new key, and the lock body, trim and finish stay on the door.
  • Patio doors, security gates and screen doors. Hookbolt and mortise-style locks on patio and security doors can often be rekeyed in place, though some are riveted into the frame and need replacing. We identify the model first and tell you what's feasible before we begin, so there are no surprises midway through the visit.
  • An honest rekey-or-replace check. Our recommendation depends on the lock, not on what's easiest to sell. A sound deadbolt gets a rekey. A corroded one gets a cylinder swap. A cracked bolt body or a bent latch gets replaced. We show you the evidence and let you decide.

What's different about Los Alamitos

Storefront doors in Los Alamitos shopping centers often use mortise cylinders and Adams Rite deadlatches that can be rekeyed without touching the door. After an employee leaves or a lease changes, a rekey is faster than replacing hardware, and any landlord-required hardware stays in place. We cut keys for current staff and record the keying for your files. Most storefront rekeys finish before opening hours, with no disruption to customers.

Family homes in Los Alamitos accumulate keys: kids, sitters, neighbors, relatives. A rekey resets the lot. We keep the locks you chose and give you a fresh set, then help you decide who truly needs one. It is a sensible habit to rekey when a teenager's friend group changes, a nanny leaves or a child moves out. A single visit can cover the front door, back door, garage entry and side gate together.

Older Los Alamitos homes often have hardware worth keeping: a heavy brass entry set, a mortise lock original to the door, glass knobs with a deadbolt added later. Replacing those means new bores, filled holes and a different look. Changing the key keeps the character. We rekey or swap the cylinder, keep the trim, and tell you plainly if the lock body is tired enough to retire.

Example situations

  • A shop owner in Los Alamitos lets an employee go, and that employee kept a key to the back door. The storefront has a keyed mortise cylinder and an Adams Rite deadlatch. We rekey both cylinders, cut keys for the current staff and leave the door itself untouched, so the shop opens on schedule the next morning with no hardware to repaint.
  • When a home health aide's contract ends, a family wants the parent's locks changed without fuss. The front door has a newer keypad lock and an older deadbolt. We rekey the deadbolt and the keypad's backup cylinder, update the codes with the family, and leave the parent with one easy-to-grip key and a short note of who holds which code.
  • A family has handed out the keypad code and the backup key for their smart deadbolt to a dozen people over the years. We rekey the backup cylinder, walk them through clearing old codes in the app and set two fresh ones. The hardware stays, the access list starts over, and the family finally knows exactly who can get in.
  • A homeowner whose deadbolt has stiffened over years of sun and sprinklers asks for a rekey. When we pull the cylinder, it's corroded beyond re-pinning. We fit a new cylinder of the same keyway into the existing lock, so the deadbolt, trim and finish stay, the key turns freely again, and nobody has to repaint or refit the door.

From your call to the finished job

  1. Describe the lock and why the key needs to change. Call (951) 903-3193 and tell us what happened: lost keys, a move, a roommate who left. Describe each lock or send photos of the brand, the latch edge and the keyhole. That tells us whether a rekey is likely, and what to bring to your door.
  2. Show that you're allowed to change it. California's Locksmith Act, administered by the Bureau of Security and Investigative Services, is why licensed locksmiths ask these questions. Our license is LCO7891, and you can look it up at search.dca.ca.gov. The check takes a minute and protects you as much as us.
  3. Inspect the lock and choose rekey, cylinder swap or replace. Alignment problems often disguise themselves as lock problems. If the bolt drags because the door has shifted, we adjust the strike or hinge screws first. Then we decide whether the cylinder needs any work at all.
  4. Remove the cylinder and re-pin it. On a deadbolt, the cylinder comes out through the bolt body; on a knob, through the rose or a release tab. The method differs, the idea doesn't: expose the plug, swap pins, reassemble. We work over a tray so nothing rolls away into the planter bed.
  5. Test the new key and the working door. We test the new key in each lock, in both directions, with the door open and then closed. We try the old key to confirm it no longer turns. Then we make sure the bolt throws fully into the strike and the latch catches smoothly.
  6. Hand over keys and check what's left. You receive the new keys, usually several, cut on site. We then walk through what a key change doesn't touch: keypad codes, app guests, garage remotes and spare keys held by relatives. Taking a few minutes for that review closes the gaps a new key can't.

How we quote the job

  • How many keyed cylinders you're changing. The count of keyholes drives time on site more than anything. A single front-door deadbolt is a quick job. A house with a front door, back door, garage entry, side gate and shed is several jobs in one visit. Tell us the total when you call and we quote accordingly.
  • Brand, keyway and security level. Some locks have proprietary cylinders that only the maker's parts can fit. Tell us the brand and model, and we'll check whether a rekey is possible and which parts are needed. That avoids discovering a problem halfway through a visit.
  • How many new keys and what type. Standard brass blanks are inexpensive and quick to cut. Colored-head, large-head and restricted blanks cost more but solve real problems: finding the right key in the dark, helping arthritic fingers or controlling copies. We'll show the options at the door.

Every job gets a clear quote before any work starts. Call (951) 903-3193 with the details and we'll tell you what to expect for your situation in Los Alamitos.

What not to do

  • Leaving old keys mixed in with new ones. After a rekey the old keys no longer work, but they look identical. A family member who grabs the wrong one gets locked out. Remove the dead keys from every ring and mark the new ones with a colored cap.
  • Rekeying a lock that is already failing. If the bolt is cracked, the plug is corroded or the latch sticks, new pins won't help. You pay for the rekey and then for a replacement. Have the lock inspected first so the money goes into the right fix.
  • Waiting for the next lost key. A key that has gone missing doesn't announce where it is. The sooner you rekey, the sooner a stranger's copy becomes useless. Putting it off for months leaves your doors on a combination someone else may hold.

Practical tips before you call

  • Remember the electronics. A new key does nothing about keypad codes, app guests, garage remotes or a smart hub that still has an ex's phone on it. Make a list of every way into the house that isn't a key and change those at the same time.
  • Use a puff of graphite or PTFE spray in the keyway once a year, never household oil. Oil traps dust and bakes into gum in a hot, dry climate, while a dry lubricant keeps the new pins moving and the key turning without effort.
  • Renting? Ask in writing. Most leases make the landlord responsible for locks, and some forbid changes. Get permission by email or text and keep it. California law sets specific duties for landlords on deadbolts and protective-order lock changes, so the conversation is worth having.
  • Hold on to one working key until the visit. A rekey is easier when the lock turns freely with a key in hand. If none of your keys work, tell us when you call; it's still doable, but we need to plan for opening the lock before changing it.

Getting to Los Alamitos

Los Alamitos is about 63 miles from our San Bernardino base, roughly 68 minutes in light traffic via I-215 South through Colton and Grand Terrace to SR-91 West in Riverside, SR-91 West through Corona and the Santa Ana Canyon to I-605 South toward Katella Avenue for central and west Los Alamitos. When you call, you get an arrival estimate based on where the technician is and the traffic at that moment.

Homes and businesses just off Cerritos Avenue are routine stops for us. Give the suite or unit number and any gate instructions, and say whether the van can park out front or should pull into a side lot.

About Los Alamitos: Los Alamitos incorporated on March 1, 1960, covers about four square miles, and counted 11,780 residents in the 2020 census.

NeighborhoodsRossmoor Highlands, Dutch Haven, Greenbrook, Suburbia, Old Town West, Los Alamitos Terrace
ZIP codes90720, 90721
Main routesI-605, I-405, SR-22, Katella Avenue
From our San Bernardino baseabout 63 miles via I-215 South through Colton and Grand Terrace to SR-91 West in Riverside, SR-91 West through Corona and the Santa Ana Canyon to I-605 South toward Katella Avenue for central and west Los Alamitos; alternate SR-57 South to SR-22 West (Garden Grove Freeway), exiting at Seal Beach Boulevard or Los Alamitos Boulevard when the 91 is jammed

Planning a rekey in Los Alamitos?

Call (951) 903-3193 and tell us how many doors you want on the new key and the brand of the locks if you know it. We'll quote the rekey before any work starts.

Frequently asked questions

Will the lock look different or need new holes drilled?

No. When we change the key, the lock stays on the door exactly as it is: same handle, finish, bore and screw holes. Nothing needs drilling or filling. The only visible change is a new key. If we swap a cylinder, the face may differ slightly in finish, and we match it as closely as the maker's parts allow.

Can you change just one lock instead of the whole house?

Yes. If only one door is a problem, we change that one. Just remember that the new key won't match the others unless we pin them alike. Many people change the key on one lock after a loss, then decide to match the rest so they carry a single key. We lay out the options and price each one.

Do I need to be home while you change the key?

We need someone present at the start to verify ID and proof of residence or ownership, show us the locks and approve the quote. After that, you can step away while we work, though most people stay to watch. For a rental or business, an authorized manager can sign off. New keys go to a verified person only.

Can a Kwikset SmartKey lock get a new key without calling you?

Yes, if you have a working key and the learn tool. Kwikset's reset has you turn the current key a quarter turn, push the tool into the small hole on the face, then swap in the new key and turn it back. Follow the steps for your model. If the key is lost or the lock jams, call us and we'll reset or replace the cylinder.

Will my old keys still work afterward?

No. Once the pins are changed, the old key lifts them to the wrong heights and can't turn the plug. We test the old key to prove it, then hand you the new ones. The only exception is if you ask us to match the lock to an existing key, in which case that key and any copies of it still work, so we ask who has them.

What actually changes inside the lock?

Only the pins in the cylinder. Each chamber holds a key pin, a driver pin and a spring. We swap the key pins for sizes that match your new key, which moves the shear line to a new position. The bolt, latch, springs and mounting parts stay the same. It's a small mechanical change, not a rebuild, and it's why a rekey often costs less than a new lock.

How far is Los Alamitos from your base?

Los Alamitos is about 63 miles from our San Bernardino base, roughly 68 minutes in light traffic. Arrival time depends on traffic and on the job the technician is finishing, so we give you an estimate on the phone before you commit.

Change Key without Replacing Lock in nearby cities

From the blog

Call now(951) 903-3193

Daily 6:30am–11:30pm